RAB Lighting DLED4R Installation Instructions

DLED4R DLED6R INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
SAFETY INSTRUCTIONS
WARNING: Risk of fire or electric shock. LED retrofit Kit installation requires knowledge of luminaires electrical systems. If
not qualified, do not attempt installation. Contact a qualified electrician.
WARNING: Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and
dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the
input rating of the luminaire.
WARNING: Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
MOUNTING
DLED Retrofit unit is designed to fit nominal Existing
Housings with openings of 4" (DLED4R) or 6" (DLED6R).
See the list of compatible housing provided on page 2.
Thread the E26 Socket Adaptor into Existing
1.
Housings Medium Base Socket.
Connect the orange Wire Connector of the E26
2.
Socket Adaptor to DLED4R or DLED6R connector.
3. Carefully route all wires into Existing Housing (Fig.
2). Taking care not to pinch wires, squeeze either
Friction Blades (DLED4R) or Torsion Spring Arms
(DLED6R) and push up DLED4/6R.
Push up on DLED4/6R until it is flush to the ceiling
4.
surface.
DLED4R
E26 Socket Adaptor
Wire Connector
Friction
Blade
5.10"
DLED4R
DLED6R
7.39"
DLED6R
Fig. 1
Torsion
Spring Arm