Run The Getting Started Wizard; View The Transport Leds And Startup States - Digi TransPort WR11 Quick Start Manual

Hide thumbs Also See for TransPort WR11:

Table of Contents

Run the Getting Started Wizard

If your PC is configured to automatically get an IP address, it can obtain the IP address from the TransPort WR11. Otherwise, make sure your PC

can connect to the network 192.168.1.0 (255.255.255.0).

1. Enter 192.168.1.1 into the address bar of the web browser.

2. The first page of the Getting Started Wizard appears. This wizard guides you through initial configuration of your TransPort device.

To run the wizard, click Get Started.

To manually configure the TransPort device, click Skip Wizard.

Note

The default username and password for logging in to the TransPort device are username and password.

Service LED: Indicates the presence and level of cellular service running on the device.

Off: No cellular service

1 blink: GPRS mode

2 blinks: EDGE mode

3 blinks: UMTS mode

4 blinks: HSDPA mode

5 blinks: HSUPA mode

6 blinks: LTE mode

Signal LED: Indicates the strength of the cellular signal.

Off: Poor or no signal. Place the device in a location where it gets a better signal.

Amber: Fair

Green: Good

Power LED:

Off: No power

Green: TransPort device is powered

After the Getting Started Wizard completes, the TransPort web interface appears. For additional configuration, use the web interface and refer

to the Digi TransPort User Guide and Application Notes on the Digi website at www.digi.com/support/TransPortWR11.

Table of Contents

Do you have a question about the TransPort WR11 and is the answer not in the manual?

Transport wr11 xt