Holy Stone HS210 Instructions For Use Manual page 13

< GENERAL INFORMATION >
ettre le fonctionnement. mauvais fonctionnement de I'appareil.
Cet appareil numériquie de la classe B est conforme à la norme
NMB-003 du Canada.
CAN NMB-3 (B)
RF Exposure
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should
be installed and operated with minimum distance 20cm
between the radiator & your body.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux
rayonnements IC établies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec un
minimum de 20 cm de distance entre lasource de rayonnement
et votre corps.
HOW TO RECYCLE THIS PRODUCT
This symbol on the product or its documentation indicates that it
must not be disposed of with household waste.
Uncontrolled waste disposal may harm the environment or human
health.
Please separate your device from other types of waste to recycle it
responsibly.
-22-
< GENERAL INFORMATION >
This will help to foster the sustainable re-use of material resources.
We invite you to contact your retailer or inquire at your local town
hallto find out where and how the drone can be recycled.
BATTERY WARNING:
1. Failure to follow all the instructions may result in serious injury,
irreparable damage to the battery and may cause a fire, smoke or
explosion.
2. Always check the battery's condition before charging or using it.
3. Replace the battery if it has been dropped, or in case of odour,
overheating, discolouration, deformation or leakage.
4. Never use anything other than the approval LiPo charger the
battery. Always use a balancing charger for LiPo cells or a LiPo cell
balancer. It is recommended that you do not to use any other
charger than the one provided with the product.
5. The battery temperature must never exceed 60°C(140°F)
otherwise the battery could be damaged or ignite.
6. Never charger on a flammable surface, near flammable products
or inside a vehicle(perferably place the battery in a non-flammable
and nonconductive container).
7. Never leave the battery unattended during the charging process.
Never disassemble or modify the housing's wiring, or puncture the
cells. Always ensure that the charger output voltage corresponds to
the voltage of the battery. Do not short circuit the batteries.
-23-