Other Functions; Care And Maintenance; Troubleshooting Guide - Beurer BF 70 Instructions For Use Manual

• On the other hand, if your weight increases in the medium term and your body fat percentage drops or
stays the same, you may have increased your muscle mass.
• If your weight and body fat percentage both fall at the same time, then your diet is working – you are los-
ing fat mass.
• Ideally, you should support your diet with physical activity, fitness or strength training. This enables you
to increase your muscle percentage in the medium term.
• Body fat, body water, and muscle percentages should not be totaled, since muscle tissue also contains
compo nents made of body water.

8. Other functions

User assignment
It is possible to assign up to eight users for weight-only measurement (with shoes) or analysis (bare feet). For
a new measurement, the scale assigns a measurement to the user whose most recently saved measurement
is within 4 lb or 2 kg of the active measurement and within 2% of the body fat.
Unknown measurements
If a measurement cannot be assigned to a known user, it is stored as an unknown measurement. Up to 20
unknown measurements can be saved. Use the app to directly assign unknown measurements to a user.
Saving the assigned measurements on the scale
If the app is open and your mobile device is paired with the scale via Bluetooth
ments are sent to the app and not saved on the scale. If the app is not open, the newly assigned measure-
ments are saved on the scale. A total of 30 measurements per user can be saved. The saved measurements
are transferred automatically to the app if you open the app within Bluetooth
takes place within 10 seconds. It is also possible to transfer data when the scale is switched off.
The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use
®
of such marks by Beurer North America LP is under license. Other trademarks and trade names are those
of their respective owners.
Deleting scale data
To delete all measurements and old user data on the scale, switch on the scale and press and hold the reset
button for three seconds; "dEL" will appear in the LCD Display.

9. Care and Maintenance

Replacing Batteries
Your scale is equipped with a low battery indicator. If the batteries are weak, " " will appear in the LCD
Display and the scale will automatically shut off. In this case, replace the batteries with three new AAA-size
alkaline batteries.
Cleaning
Clean the scale periodically using a damp cloth and, if necessary, a small amount of mild detergent.

10. Troubleshooting Guide

If the scale encounters an error during measurement, the following is displayed:
Display
" "
Cause
Unknown measurement as it is
outside the user assignment limit
or a unique assignment is not pos-
sible.
9
, newly assigned measure-
®
range. Data synchronization
®
Remedy
Assign unknown measurement in
app or repeat user assignment.