Viking E-1600A-BLT-EWP Product Manual page 4

IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC outlet and the
telephone line. It is recommended that a surge protector be installed to protect against such surges.
BLK-4 Control
Module (included)
rotated 90°
Red with
Incoming
Yellow stripe
Analog
Phone Line
Green with
Yellow stripe
Note: Not polarity sensitive.
Phone or
Terminal
Brown
Device
(not included)
Disable Feature
(see section E on page 6)
White
Trigger Input for Optional
Remote Trigger Switch
(see section G on page 6) White
* Note: To increase surge protection, loosen the PCB mounting screw labeled
(included) from the mounting screw to Earth Ground (grounding rod, water pipe, etc.)
** Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a maximum
insulation of 0.082 inches. Cut off bare wire ends prior to terminating.
*** Note: When wires are routed from above, a "drip loop" is recommended to keep water away from the circuit board.
Rear View of the
Phone Panel
ON ON
Gray
Blue
Blue
Wiring
Ring Connector
(included)
1 2 3 3
* Earth Ground
** Gel-Filled Butt
Connectors (included)
Note: Polarity Sensitive!
(+) Red with
Black stripe
(-) Black with
Red stripe
Rear View of the SL-2
Strobe Light
see Programming page 6
Red (+)
Black (-)
Green (see section F page 6)
Black
Red
Auxiliary Relay Contact Output
(see section D on page 5)
Orange
Purple
Yellow
(as shown) and fasten a wire with ring connector
4
(optional)
120V AC
12V DC
Adapter
(included)
Positive
Negative
(included)
Rear View of Legacy
SL-1 Strobe Light
(included with 2012 and older
E-1600A-BLT-EWP models)
*** Drip
Loop