Air-Conditioning With Installation - DeLonghi PINGUINO PAC CN86 Instruction Manual

Air-conditioning with installation

If required, your appliance can also be installed semi-
permanently (Fig. D).
D
Proceed as follows:
• Drill a hole (ø134mm) in an outside wall orthrough a
window pane. Respect the height and dimensions of
the hole given in figure E.
E
in the window in the wooden
pane kickboard of a French
window
Important! Keep the air hoses as short and free of
curves as possible to avoid constrictions.
Fit the wall flange accessory 11 provided in the hole.
•
Fit the air exhaust hose 13 in the relevant hose 7 located
•
on the rear side of the appliance (see fig. A).
Screw the wall mounting accessory 14 from the air
•
exhaust hose 12 or, if necessary, unscrew the hose
adapter 13 from the air exhaust hose 12 and replace it
with the wall installation terminal 14 (fig. F).
in the wall: you are
recommended to
insulate the section
of wall using
suitable insulation.
16
F
• Insert the other end of the hose 12 onthe flange 11 as
shown in fig. G.
G
When the hose 12 is not fitted, the hole canbe closed
•
with the flange cap 11.
Please note: When installing the air conditioner semi-
permanently, you should leave a door slightly open (as
little as 1 cm) to guarantee correct ventilation.
Use
MAX100 cm
MIN 35 cm