Table of Contents
Advertisement
R
Q
Description of the control panel
A
ON/OFF button
B
MODE selection button
Air conditioning, dehumidifying, fan.
C
Fan speed selection button
(MAX/MED/SILENT)
D
Timer button
E
Programmed operation increase temperature/time
button
F
Programmed operation decrease temperature/time
button
Important!
Never turn the air conditioner off by unplugging from the mains. Always press the
a few minutes before unplugging. This allows the appliance to perform a cycle of checks to verify operation.
OPERATION
Turning the appliance on
Please note: Before plugging the appliance
check: the caps on the back of the unit are correctly
inserted and screwed on the drainage hose 10.
Plug the appliance into the mains. Press the ON/OFF button
(A) (when turned on, the air conditionerstarts operating in
the same mode as when it was turned off). The display shows
the room temperature. Press the MODE button (B) until the
indicator light correspondingto the required mode lights up:
Light (O): air-conditioning mode
Light (N): fan mode
Light (P): dehumidifying mode
Control panel/ Operation
C
I
L
F
M
S
D
G
E
P
O
B
T
N
G
Display: Displays the temperature values set, room
temperature and the programmed operating time
H
Timer in operation indicator light
I/L/M Fan speed lights
N
Fan mode light
O
Air-conditioning mode light
P
Dehumidifying mode light
Q
Alarm light
R
Remote control signal receiver
S
Light: displays room temperature
T
Light: displays set temperature
Air-conditioning mode
Ideal for hot humid weather when you need to cool and
dehumidify the room. By default, the room temperature is
displayed. Light (S) is on. To set the required temperature,
press the + (E) or - (F) buttons until the required temperature
is displayed (to switch between °Fand °C, press the E and F
buttons together for a few seconds). Light (T) comes on
and light (S) goes off. Fifteen seconds after setting the
temperature, the display swit-ches back to room temperature.
Light (S) comes on again. You can adjust temperature in air
conditioning mode only. Then select the fan speed by pressing
the FAN button (C) untilthe indicator light corresponding to
the required fan speed lightsup:
MAX:
the air conditioner operates at maximum to reach
the required temperature as rapidly as possible.
MED:
reduces noise levels but still maintains a good level
of comfort
SILENT: for silent operation
17
en
A
H
button, then wait for
Hide quick links:
Advertisement
Table of Contents
