To Remove Snow Thrower From Carton; How To Set Up Your Snow Thrower; Assembly; Cable - Craftsman 536.886531 Owner's Manual

Figure 1shows t hesnow
thrower in the shipping position
Figure 2 shows the snow thrower completely assembled
Reference to the right and left hand side of the snow
thrower is from the operator's position at the handle.
TO REMOVE SNOW THROWER
FROM CARTON (See Fig. 1)
• Remove staples from the top of the carton
• Locate and remove container of 5W30 oil.
• Locatethe crank assembly and place the assembly
aside
o Remove and discard the packing material from
around snow thrower
o Cut all four corners of the carton from top to bottom
and lay the panels flat
= Remove the packing material fromthe control panel
and upper handle assembly
• Rollthe snowthrower off the carton by pulling onthe
lower handle+
CAUTION: Do Not back over cables
® To complete upper handle instaltation and install
chute crank assembly, see To Install The Upper
Handle and Crank Assembty paragraph on page 8
ii iin,,
FIG. 1
CABLE
UPPER
HANDLE
ASSEMBLY
NOTE: If the cables have become disconnected from lhe
clutch levers, reinstall the cabfes as shown in Fig, 3.
HOW TO SET UP YOUR SNOW
THROWER
Your snow thrower is equipped with height adjust
skids (See Fig 2) on the outside ot the auger hous-
ing. To adjust the skid height for different conditions,
see To Adjust Skk:l Height paragraph on page 17+.
" CAUTION: IF' YO'U'"'ARE 'R'E'r_0VING
SNOW FROM ANY GRAVELED OR UJ_-
EVEN SURFACE, RAISETHE FRONTOF
THE SNOW TH ROWER BY MOVING THE
SKIDS DOWN+ THIS WILL HELP TO PREVENT
STONES AND OTHER DEBRIS FROM BEING
PICKED UP AND THROWN BY THE AUGER.
"Z" FITTING
FIG. 2
TRACTION
DRIVE
LEVER
7