Parts packed separately
in carton (not shown full size)
2- Ignition Keys
(Attached
to engine in plastic bag)
1-Snow
Chute Assembly
IIIIIII
I
I •
_
ARNING: Always wear
satety glasses or eye shields
while assembling
snow
thrower.
TOOLS
REQUIRED
FOR
ASSEMBLY
1 - Knife to cut carton
1 - 1/2 inch wrenches
(or adjustable
wrenches)
1 - 9/16 inch wrenches
(or adjustable
wrenches)
1 - 3/4 inch wrenches
(or adjustable
wrenches)
1 - Pliers (to spread cotter pin)
1 - Screwdriver
1 - Measuring
tape or ruler
Figure 1 shows the snow thrower in the
shipping position.
Figure 2 shows the snow thrower com-
pletely assembled.
References
to the right or left hand side
of the snow thrower are from the view-
point of the operator's
position behind
the unit.
Auger Drive Lever
Traction
Drive Lever
Shifter
Lever
Clutch Cable
Crank Assembly
Chute
Deflector
F-001087J
Figure 1
7
Height
Adjust
Skid
Figure 2
TO
REMOVE
SNOW
THROWER
FROM
CARTON
1.
Locate all parts packed separately
and remove from the carton.
NOTE:
Place fuel stabilizer in a safe
place until needed for storage.