Walther WTRB-24DC-3500 Operating Manual page 34

Rev. 1.0
Outputs (OutL, OutA)
The configuration of the device outputs is divided into binary outlets (OutL) and analog outlets (OutA). Switch-
ing statuses of the binary outlets 1 to 3 (5) will be indicated by the LEDs K1 to K3 (K5) (LED on = outlet ac-
tive).
Binary Outputs
As a standard, the device comes with a relay output (make contact; output 1); optionally, it can be equipped
with two (four) additional binary outlets (relay or logic output; outlets 2 to 5).
ConF -> OutL->
Parameter
Output 1 ... 5
Out1
Out2
Out3
Out4
Out5
(Setup program: the output signal can be inverted.)
Analog Output
Optionally, the device can be equipped with an analog output (outlet 2).
ConF -> OutA->
Parameter
Function
FnCt
Type of signal
SiGn
Value for Out-of-Range
rOut
Zero point
0Pnt
Final value
End
WALTHER Temperature Controller Bundle WTRB-x-x
Value Description
0 Output not active (factory set for Out2 ... Out5)
1 Controller output 1 (factory set at Out1)
2 Controller output 2
3 Binary input
4 Limit value monitoring 1
5 Limit value monitoring 2
6 Timer signal
Value Description
9 Function of output; 9 = controller outlet 1
Physical output signal
0 0 ... 20 [mA]
1 4 ... 20 [mA]
2 0 ... 10 [V]
0 ... 101 Signal (as percentage) for exceeding or falling short of
measuring range 101 = last output signal
-1999 ... 0 Value range of the basic value for the physical output sig-
... +9999 nal
-1999 ...
100 ...
+9999
Walther Systemtechnik GmbH – D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de – info@walther-2000.de
Page 34 of 42