Pressure Relief Procedure - Graco HVLP EDGE II Operation - Repair - Parts

Pressure Relief Procedure

Pressure Relief Procedure
Follow
Procedure whenever you see this
symbol.
The spray gun cup is pressurized. To
reduce the risk of splashing from
pressurized fluid, always follow the
Pressure Relief Procedure before
removing cup.
1. Turn the HVLP sprayer ON/OFF switch
to OFF position.
2. Unplug power cord to disconnect power
from the HVLP sprayer.
3. Disconnect spray gun from air hose.
NOTE: If using a remote cup, refer to manual
provided with cup. If using with a Graco
FinishPro HVLP ProComp sprayer,
reference sprayer manual.
8
the Pressure Relief 4. If using a FlexLiner System:
Disconnect tubing from gun to relieve
pressure in the cup.
5. If using a metal siphon cup:
Unlatch cup cover, loosen or remove cup
from cover to relieve pressure.
ti30757a
ti30627a
ti30628a
3A4980B