Graco HVLP EDGE II Operation - Repair - Parts page 13

4. Install cover and ring onto cup. Tighten
ring securely.
5. Connect FlexLiner System to gun.
3A4980B
6. Connect air hose to inlet fitting of gun.
ti30683a
7. Verify trigger slide is in SPRAY position
(A).
ti30709a
ti30945a
8. With HVLP sprayer powered ON, point
gun into a waste area. Evacuate air from
FlexLiner System by holding gun
vertically and pull trigger open until a
continuous spray pattern is observed.
NOTE: Tilt gun back and forth to help in
ti30681a
evacuation of air.
ti30687a
9. You are now ready to spray. Reference
How to Spray, page 16.
Startup
13