Advertisement
This manual contains the following documents:
Page 2 Introduction / Component ID / Attachment Installation
3
Site & Detent Rail Installation **IMPORTANT**
4
Site Rail and Number Alignment Overview
5
Alignment Instructions & Tips
6
Operating Instructions & Adjustments
Alignment Guide
DiGiT Numbering System
Models: V2NS-8 & V2NS-12
Assembly and Operating Manual
Vastex E-mail assistance
Purchasing & Product Info:
sales@vastex.com
Electrical Support:
stech@vastex.com
Tech Support, Mechanical Setup, and Operation
techsupport@vastex.com
Screen Printing Issues & Support:
printech@vastex.com
Vastex International, Inc.
7 Emery St
Bethlehem, Pa. 18015 USA
Phone# 610 625-2702 Fax# 610 625-2775
Web Site www.vastex.com
Doc # 01-19-001
Advertisement
Table of Contents
Related Manuals for VASTEX DiGiT V2NS-8
Summary of Contents for VASTEX DiGiT V2NS-8
- Page 1 Models: V2NS-8 & V2NS-12 Assembly and Operating Manual This manual contains the following documents: Page 2 Introduction / Component ID / Attachment Installation Vastex E-mail assistance Site & Detent Rail Installation **IMPORTANT** Purchasing & Product Info: sales@vastex.com Site Rail and Number Alignment Overview Electrical Support: stech@vastex.com...
- Page 2 8” attachment and 30 lbs for the 12” attachment. It must also be strong enough to hold the screen level when slid to the end printing positions. Additional springs or shocks may be required for your press to hold this attachment. Vastex is not responsible for damages incurred while trying to retrofit our DiGiT to your press.
- Page 3 Site Rail Installation The Site Rail is a visual aid for selecting the desired print location of the numbers. Note 1) Loosen the three phillips head screws circled in the picture below. The Site and Detent Rails can be in- 2) Slide the Site Rail under the screw heads and tighten.
- Page 4 Site Rail and Number Alignment Overview Selected # printed on right chest. ex: Selected # printed to the right side of a #1. ex: Selected # printed on center of shirt. ex: Selected # printed to the left side of a #1. ex: Selected # printed on left chest.
- Page 5 Alignment Instructions & Tips To align your DiGiT Numbering System, please photocopy the Alignment Guide (AG) which is the back page of this manual. This page will aid you in aligning your screens. 1) Photocopy (full size) back 2) Position and attach the page of DiGiT Manual.
-
Page 6: Operating Instructions
3/8” to ensure the screen locks fully into the Detent Rail. required for this to function correctly. 5) Install (optional) Vastex Squeegee Rest onto screen. 10) For printing two color numbers, rotate the pallet under the 6) Ink the screens with athletic ink. For athletic numbering tips, flash then proceed with the outline or drop shadow. - Page 8 Center of Pallet 11/19/15 DiGiT Alignment Guide Follow these steps for each attachment being used 1) Mark a center line on pallet. 2) Center this sheet on pallet. 3) Set height from front edge of pallet. 4) Line up the Alignment Marks when centered on #s 1, 5, 6 & 0 5) No bulls -eyes on your number screen? Simply use guide lines on this template to center and align your numbers.
Need help?
Do you have a question about the DiGiT V2NS-8 and is the answer not in the manual?
Questions and answers