Connection cover Wall mount screw key-holes Warnings If MPS12-30 is hotter than usual, or the battery is hot or • swollen, disconnect from AC socket/outlet, switch off AC power switch ( ), and contact your MPS12-30 supplier.
Page 3
• Specifications (on next page) for the recommended temperature range. 2. Either: Mount the MPS12-30 on its back on a flat, firm surface, or • Mount it on a wall with two screws (see below). If needed, • use wall anchors or plugs to suit the type of wall and the weight of the MPS12-30.
Page 4
After five minutes, check the AC On light (green ) has stopped flashing and no other lights are on. If any other lights are on, or if the MPS12-30 beeps see below. What the lights and alarm sounds mean Light and Alarm...
How to replace the battery Contact your MPS12-30 supplier to purchase a replacement battery. Warning: Risk of explosion if incorrect battery type is used. Battery can be replaced with MPS12-30 connected to AC wall socket/outlet. 1. Press the battery cover and 5.
Information contained in this document is subject to change without further notice. Subject to the right to use its equipment, Eaton Corporation does not convey any right, title or interest in its intellectual property, including, without limitation, its patents, copyrights and know-how.
1. Press the battery cover and 5. Connect the wires to new Information contained in this document is subject to change without further notice. Subject to the right to use its equipment, Eaton Corporation does not convey any slide up. battery. Red: positive (+), right, title or interest in its intellectual property, including, without limitation, its Black: negative (-).
Page 8
1. Select a suitable location for the MPS12-30: If any other lights are on, or if the MPS12-30 beeps see below. Close to an AC power socket/outlet. The AC power cord is •...