Threading Top Thread - Kenmore 1340 Owner's Manual

IIIIIIII IIIII IIIII I IIII IIIIIIIIII IIIII II
THREADING TOP THREAD
...........
10
Raise thread take-up lever to its highest
position by turning hand wheel toward you.
Raise presser foot lever. Place thread spool
on spool pin,
Draw thread through thread guide 1.
Holding spool stationary with right hand,
pull thread through the tension discs. Pull
the end of the thread taut with the left hand.
2_
3_
This will pull the spring wire up and past the
end of the hook. The thread will then slip
into the hook when the spring is released.
Draw thread up through thread guide 4 take-
up lever 5 and down through lower thread
guides 6, 7, 8 to needle.
The needle must be threaded from front to
rear, Draw 3 to 4 inches of thread through
the eye of needle.