Setting Up Your Machine; Installing Extension Table - Kenmore 1340 Owner's Manual

• I IIIIIIIIIIIIIIIIIIIII J
Light(power
switch
Model 1358
SETTING UP YOUR MACHINE
1. Install your Kenmore sewing machine in a
Kenmore cabinet, case or set the machine
on a sturdy flat surface.
2. Your Kenmore sewing, machine has been
throughly oiled at the factory. Be sure to
wipe off the needle plate area, bed plate
and bobbin case carefully before sewing a
garment, It is wise to practice on a scrap
of fabric so any surplus oil is absorbed,
3. SPOOL PINS
You'll find spool pins and nylon discs
packed in the accessory box. Using a
screwdriver, attach spool pins securely on
the top cover and position nylon discs
over the spool pins as indicated.
4. FOOT CONTROL
Plug foot control into machine receptacle.
Then connect cord into any 110-120 volt
A. C. wall outlet,
5. LIGHT/POWER SWITCH
Your machine will not operate unless the
light/power switch is turned on. Turning
on the power automatically illuminates
the whole stitching area. If you're
interrupted or stop sewing, turn off the
light/power switch.
(A)
INSTALLING EXTENSION TABLE
For all fiat-bed sewing use the extension table
provided with the machine. To install the
extension table, simply slide the table along
the free arm until the two pins (A) and (B)
enter fitting holes in the machine, Lower the
support leg.
To utilize free-arm feature for sewing tubular
material, remove the extension table from the
machine by pulling it to the left.