Kenmore 1340 Owner's Manual page 31

HIIIIIIIIIIIIIII!IIIIIIIII I II I IIIIIIIII
APPLIQUEING
SETTINGS
Stitch Selector - Zigzag Stitch
Stitch Length Dia! - Between 0 and 24
Satin Stitch Foot
Select an applique design to be applied to
your garment and baste it in place. Satin
stitch around the raw edge of the-applique
completely covering the edge. You may want
to do this with a contrasting color of thread.
BUTTON SEWING
SETTINGS
Stitch Selector - Zigzag Stitch
Use Feed Cover Plate or Feed Dog Down.
1. Fix the button on fabric at desired
position with clear tape.
2. Align two holes of button with slot of
presser foot and lower foot to hold the
button securely.
3. Turn hand wheel manually until needle
point is just above button.
4. Set stitch selector at desired zigzag stitch
position so needle will enter one hole of
the button.
5. Turn hand wheel again by hand so needle
enters second hole. Reset stitch selector
if necessaw. Stitch a number of times.
6. Finish sewing with an extra two inches of
thread remaining. Draw these threads to
reverse side of garment and tie.
When sewing a flat button, place needle or
pin between holes of button as shown to
provide flexibility for buttoning,
3O