Craftsman 113.241591 Owner's Manual page 35

Feed the workpie'ce by hand along the AUXILIARY
FENCE until the end is approx. 1 in. past the front
edge of the table. Continue to feed using the PUSH
BLOCK.
Hold the workpiece in position and install the PUSH
BLOCK by sliding it on top of the AUXILIARY
FENCE/WORK SUPPORT (This May Raise Guard)-
BAFFLE
Narrow strips thicker than the Auxiliary Fence/Work
Support may enter the guard and strike the baffle.
CAREFULLY raise guard only enough to clear the
workpiece. Use PUSH BLOCK to complete cut.
PLOUGHING AND MOLDING
PLOUGHING is grooving with the grain the long
way of the workpiece, using the fence. USE
Featherboards and push sticks as required.
MOLDING is shaping the workpiece with the grair
the long way of the workpiece, using the fence. USE
Featherboards and push sticks as required.
I
PLOUGHIN
MOLDING
35