Craftsman 113.241591 Owner's Manual page 16

5. Remove the plasticcovers fromthe endsof the
SHAFTHOUSING.
SAW ARBOR
MOTOR END d _ --. END
6. Push the saw arbor end of the flexible shaft out
of the SHAFT HOUSING until it is
approximately 1 inch above the end of the
SMALL FERRULE.
PULL FLEXIBLE SAW ARBOR END
SHAFT OUT 1"
7. Insert the flexible shaft assembly through the
opening in the side of the saw base. Line up the
SQUARE END of the FLEXIBLE SHAFTwith the
square hole in the arbor shaft, holding square
end of flexible shaft insert the FLEXIBLE SHA F]-
into the square hole in the arbor as far as it wil I
go.
IMPORTANT: Make sure the FLEXIBLE SHAFT is
inserted as far as it will go. Approximately 3/4
inch.
L_[
©
O
SHAFT RETAINER
PAN HEAD SCREW
10-32 x 3/8 iN.
|6