Craftsman 113.197511 Owner's Manual page 21

Attach Side Panels to Bottom Shelf
1. Set out:
-eight v4" diam x v2" long truss head
screws
-eight vg'diam lock washers
-eight W' diam hex nuts.
2. Put bottom shelf on floor so bottom
surface faces you and angled end of lower
support points up. Slide right side panel
into place so four holes in side panel line
up with four holes in bottom shelf.
3. Attach panel to shelf: use four screws
(insert screws through side panel); on end
of each screw put washer, then nut, and
wrench tighten.
4. In similar way, attach left side panel.
Attach/Install Spacers
D_oxlr _ITHOUT Casters:
1. Set out:
-two v4" diam x v>."long truss
head screws
-two 74"diam lock washers
-two 5_" diam hex nuts.
2. Attach spacers to bottom shelf: use one
screw per spacer (hzsert screw through
spacer); on end of screw put washer, then
nut and wrench tighten.
Door Model WITH Casters and Drawer;
1. Set out:
-two spacers
-two v4" diam x 1" long truss head
screws
-two 1/g'diam lock washers
-two 1/4"diam hex nuts.
2. Push foot levers down and towards out-
side so they will release and unlock foot
assemblies.
Assembly
Angled End Of
Lower Support
Bottom Side
Of Shelf
Right Side
Panel
Side
Panel
\,
Side View
®
I
Spacer
"_'- Shelf
21