Table of Contents
Advertisement
Installation
Do not lift the ovens using the control enclosure. Lift
from the main oven cavity only. Damage may occur to
the controls of the oven if lifted by the control enclosure.
Uncrate the unit. Remove all finger components, the
conveyor, and the front door, along with all four door knobs.
The unit can then either be placed on the left side (the side
opposite to the control box), or preferably on the front
(door) side, on a four wheel moving dolly, and it will clear a
30" (762 mm) doorway.
Manual Gas Valve Installation
When installing the gas valve that is supplied with the oven
it is our suggestion that an elbow be placed on the oven
pipe first. This will allow the flexible hose to be attached in a
downward direction, eliminating possible stress to the hose.
Stand and Finger Assembly
STAD ASSEMBLIES
1. For Single Stack Ovens: The stand is a 50" (1270 mm)
x 40" (1016 mm) rectangle. Set it in place with a 50"
side facing out. This will be the front of the oven. Ovens
on casters require a level floor. NOTE: The oven top is
packed with oven stand. Remove top from stand before
assembly.
14
otice
P/N 4001
2. Oven Placement: Remove the oven from the dolly and
set it on the stand. The control panel should be on the
right rear as you face the oven. Be sure that the oven
sets squarely on the stand and is fully seated. For a
single oven, install top.
n
Verify the four brackets are fully assembled to the door.
The door must be fully assembled, as shown below, to
avoid injury during installation and operation.
Part Number 11020000499 Rev B (1/17)
Section 2
Warning
Hide quick links:
Advertisement
Table of Contents
