Before Calling for Service Checklist
Problem
Doesn't operate
Uneven heating
Over or under cooked
Heat and cooking odors spill into room
Conveyor does not operate
Thermal Cut-Out Switch for Control Box
Components
The Electric 3240 ovens (both 50 Hz and 60 Hz) include a
"safety thermal cut-out switch" for your protection. This
safety related device is designed to ensure that the unit
will not overheat and damage the oven. In the unlikely
event that the oven would exceed the specified operating
temperature range, the "safety thermal cut-out switch" will
activate, thus blocking power to the unit and causing it to
turn off. The Gas 3240 ovens (both 50 Hz and 60 Hz) are not
required to have this safety feature.
28
Section 5
Troubleshooting
Cause
Breaker tripped
Safety thermal cut-out trips (Electric ovens)
No gas (Gas ovens)
Fingers incorrectly assembled
Fingers in wrong location
Oven temperature not stabilized
Incorrect temperature setting
Incorrect conveyor speed
Temperature control out of calibration
Ventilation/exhaust hood is off
Ventilation/exhaust filters require cleaning
Defective ventilation/exhaust system
Incorrectly installed
Drive sprocket is loose
Drive chain loose or disconnected
Conveyor has stretched from use
Correction
Reset breaker
Reset power, call for service if it repeats
Check gas valve is "ON" and gas hose
connection is properly attached
Reassemble correctly
Place fingers in correct location
Allow oven to stabilize for 30 minutes
minimum after any change to cook
temperature
Adjust temperature
Adjust conveyor speed
Call for service
Energize the ventilation system
Clean all filters
Call for service
Remove and reinstall
Tighten drive sprocket
Verify installation is correct - Call for service
Call for service
Part Number 11020000499 Rev B (1/17)