Electronic Alert & Diagnostic System; When Your Refrigerator Is First Plugged In - Kenmore 8EAIRS Owner's Manual

Electronic Alert & Diagnostic System
LZIE!
p_:POWER
dE DEFROST
_ FRBS_
El !CEMAKER
WATER
Kenmore
(_ Red signal light flashes to tell you when either door is
open,
(_) Signal light tells you that the Door Alarm beeper has
been set to sound after either door has been open 30
seconds_
(_) Red signal light tells you when freezer foodkeeping
temperature is above normal.
(_ Lighted word normal indicates that no
failur e has been detected by the diagnostic system
(_) Flashing diagnostic codes in the display
warn you when:
B power has been interrupted
[]defrost system has failed
11_ frozen foods should be checke&
[ icemaker may not be operating properly
What these codes mean-and what to do when they
appear-is summarized on the inside of the freezer
compartment door and explained more thoroughly on
the following pages
(_ System Check pod puts a review of the electronic
diagnosis of four coded functions at your fingertip
and also allows you to erase codes from display,
(_ Electronic control allows you to select ice cubes,
crushed ice or chilled water and signal light confirms
your choice
CUBED
,cE ] DOOR 1
l.w oN!on: ;
t
When your refrigerator is first plugged in...
All panel lights come on for five seconds, a beep sounds,
and lights go off except as follows:
• PF flashes in the display Touch SYSTEM CHECK-RESET
pad to erase it
• Word NORMAL glows
• Red W'ARM TEMPERATURE light glows if freezer
compartment temperature is higher than normal It goes
off when proper foodkeeping temperature is reached
o Door alarm beeper isactivated and light on DOOR
ALARM pad glows
" CRUSHED ice selection light glows,
Red DOOR OPEN light flashes if either door is open,
goes out when doors are shut.
° Night light in water-and-ice dispenser is off,