Water Quality; Syrup Quality; Maintenance And Cleaning; Inspect The Valve Regularly And Perform All Maintenance Procedures - Cornelius LEOPARD ERV Operator's Manual

Leopard ERV
™ Operator's Manual

Water Quality

• Chloramines are a combination of chlorine and ammonia which are responsible for some degradation of
rubber components. Installing and maintaining a water filtration system can minimize the affects of
Chloramines.

Syrup Quality

• Use only Coke approved quality syrups.
• Do not use syrup that is out of date.

Maintenance and Cleaning

!
WARNING:
Water, Syrup and CO to the system must be turned off and the system depressurized prior to performing this
2
service.
Failure to comply could result in serious injury, death or damage to the equipment.

Inspect the Valve Regularly and Perform ALL Maintenance Procedures

1. Check syrup supply regularly. Replace when depleted or out of date.
2. Check CO supply and water filters frequently. Replace when necessary.
2
3. Clean the valve as outlined in the maintenance section.
4. Sanitize the dispensing system as required for that model.
5. DO NOT abuse the valve.

Weekly Nozzle Cleaning Procedure

This cleaning procedure must be performed each week or more often if needed to maintain cleanliness of the
nozzle and inner nozzle.
• McD Sanitizer (HSC)
• Sanitizing bucket
• Nylon pot brush
NOTE: To save on operating supplies, this procedure can be combined with daily utensil cleaning
that includes wash, rinse, and sanitize at the back sink.
1. Prepare a solution of 1 packet of McD Sanitizer with 2-1/2 gallon (9.5 L) of LUKEWARM water in a
sanitizing bucket.
NOTE: Use ONLY LUKEWARM water, hot water will destroy the chlorine power of the sanitizer,
and cold water will not allow the sanitizer to dissolve. LUKEWARM is warm but not hot,
approximately body temperature.
2. Remove the nozzle from the valve by turning and pulling down.
3. Remove the syrup diffuser assembly from the valve by pulling down. Place diffuser and nozzle in sanitizer
solution.
4. Repeat Steps 2 and 3 for each valve.
5. Wipe up inside nozzle diffuser area. Use bristle brush to clean underside of valve, especially area where
nozzle and diffuser are attached.
NOTE: Do Not soak the nozzles and diffusers in the sanitizing solution for more than 15 minutes.
6. Using a nylon pot brush, clean the syrup diffusers and nozzles 1 at a time and rinse with warm water.
7. Install the syrup diffusers and nozzles back in the valve.
Publication Number: 620919579OPR - 6 - © 2004-2011, IMI Cornelius Inc.