Table of Contents
Advertisement
STEP
! 0
Installing
the Anti-Tip
Device
WARNING:
• Range
must be secured
with an approved
Anti-
Tip device_
• Unless
properly
installed,
the range could
be
tipped
by you or a child standing,
sitting
or
leaning
on an open door.
• AFter installing
the Anti-Tip
device, verify that it
is in place by carefully
attempting
to tilt the range
forward.
• This range has been designed
to meet all recognized
industry
tip standards
for all normal
conditions°
• The use of this device does not preclude
tipping
of the range when
not properly
installed.
• If the Anti-Tip
device supplied
with the range
does not fit this application,
use the universal
Anti-Tip
device WB02X7909o
1. Mark the wall where the RIGHT
EDGE
of the
range is to be located.
Be sure to allow for the
countertop
overhang
if you intend
to install the
range next to cabinets.
...._
_>_'_Anti-Tip
l
"_.¢'_
!_]] device
[
head
'_i__
'LIII
1
Approx.
20 °.
_
I
7
2¼'
""
(8,4 era)
.,,,"
Marked edge
of range
2. Locate
the outside
edge of the device 2W' (5,4 cm)
toward
the center
of the range from the marked
edge of the range.
3. Using the device as a template,
mark the position
of
the hole for the screw.
4. For wood
construction,
drill a pilot hole at an angle
of 20 degrees
from
the horizontal
A nail or awl may
be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or
concrete
construction,
you will need a
1t4" x 1_" lag bolt and a 112" O.D. sleeve anchor,
which are not provided. Drill the recommended
size
hole for the hardware,
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must
be properly tightened as recommended for the hardware.
Wallboard
Anti-Tip
device
Wood screw
Back of range
5. Slide the range against the walt, and check for
prope_ installation
by grasping the front edges of the
rear surface unit openings and carefully attempting
to tilt the range forward.
WHEN
ALL HOOKUPS
ARE
COMPLETED:
MAKE SURE ALL OF THE CONTROLS
ARE
LEFT IN THE OFF POSITION.
MAKE SURE
THE
FLOW
OF COMBUSTION
AND
"vENTILATION
AIR TO THE RANGE
IS
UNOBSTRUCTED.
Converting
to
LP
gas
(or converting
back to natural
gas from LP)
This range leaves the factory
set for use with natural
gas, If you want
to convert
to IP gas, the conversion
must
be performed
by a qualified
LP gas insta!lero
The conversion
instructions,
sticker and LP orifices
can be found
attached
to the range next to the pressure
regtflator.
There
is a second
set of instructions
included
in the
envelope
containing
the product
wiring
diagrams
on
the back of the range_ Keep these instructions
and the
orifices in case you want to convert
back to natural
gas_
39
Advertisement
Table of Contents
