Table of Contents
Advertisement
Marine Installation
Figure 12 illustrates a typical marine installation with the following
components:
1. AC power supplied from a shore power connector
2. An AC source panel that includes a Max 30A circuit breaker
that supplies the Freedom HF
3. An AC load panel with branch circuit breakers that supply only
loads that run off the Freedom HF
4. Engine negative bus / DC ground bus
5. DC power supplied by a battery bank and protected by a DC
fuse in the positive cable
6. Battery isolator
7. DC alternator
8. Starting battery
9. Drip shield (not shown)
975-0395-01-01
Figure 12 Typical Marine Installation
37
Advertisement
Table of Contents
