If Your Vehicle Must Be Towed - Hyundai Coupe Tiburon 2007 Owner's Manual

Go around the wheel tightening every
other nut until they are all tight. Then
double-check each nut for tightness.
After changing wheels, have a techni-
cian tighten the wheel nuts to their
proper torque as soon as possible.
Wheel nut tightening torque
Steel wheel & aluminium alloy wheel:
90-110 Nm. (65-80 lb.ft)
SD070K1-E
AFTER CHANGING WHEELS
OGK036605
The pressure of the spare tyre should
be checked at the first available oppor-
tunity. If any doubt exists as to the tyre
pressure, the vehicle should be driven
slowly to the nearest service station
and the tyre pressure checked and
adjusted as required.
If the valve cap is lost from any of the
valves, a replacement should be ob-
tained and fitted at the first available
opportunity. The valve cap prevents
the ingress of dirt which may cause the
valve to stick and therefore leak and is
part of the valve sealing function.
Ensure that the spare wheel, jack and
wheel nut wrench as well tools are
correctly located in the boot of the
vehicle to prevent damage and noise.
IN CASE OF EMERGENCY
IF YOUR VEHICLE MUST BE
TOWED
D080A01O-EAT
If your vehicle has to be towed, it should
be done by your Hyundai authorised
repairer or a commercial tow truck ser-
vice. This will help assure that your
vehicle is not damaged in towing. Also,
professionals are generally aware of
local laws governing towing. In any
case, rather than risk damage to your
car, it is suggested that you show this
information to the tow truck operator.
Be sure that a safety chain system is
used and that all local laws are ob-
served.
It is recommended that your vehicle
be towed with a wheel lift and dollies or
flatbed equipment with all the wheels
off the ground.
!
CAUTION:
o Your vehicle can be damaged if
towed incorrectly!
o Be sure the transaxle is in neu-
tral.
o When the engine will not start, be
sure the steering is unlocked by
placing the key in the "ACC" po-
sition.
3
11