Hyundai Coupe Tiburon 2007 Owner's Manual page 294

1
CONTROLS AND EQUIPMENT
26
U: Suitable for "universal" category
restraints approved for use in this
group
UF: Suitable for forward-facing "uni-
versal" category restraints ap-
proved for use in this group
L1: Suitable for "Römer ISOFIX GR1"
approved for use in this group
(Approval No: E1 R44-03301133)
X: Seat position not suitable for chil-
dren in this group
N/A:No seating position is provided
B230B02GK-GAT
Using a Child Restraint System
with "Tether Anchorage" Sys-
tem
Hook Holder
Bolt, Holder (5/16"-22 mm)
Washer, Conical Spring
Holder, Child Restraint Hook
Retainer Washer
HGK264L
For small children and babies, the use
of a child seat or infant seat is required.
This child seat or infant seat should be
of appropriate size for the child and
should be installed in accordance with
the manufacturer's instructions. It is
further required that the seat be placed
in the vehicle's rear seat since this can
make an important contribution to
safety. Your vehicle is provided with
two child restraint hook holders for
installing the child seat or infant seat.
B230E03GK-GAT
Securing a Child Restraint Sys-
tem with "Tether Anchorage"
System
Two child restraint hook holders are
located on the rear luggage compart-
ment floor.
Tether Anchor Cover Child Restraint
Hook Holder
OGK016230
1. Open the tether anchor cover on the
rear luggage compartment floor.
2. Route the child restraint seat strap
over the seatback.
For vehicles with adjustable head-
rests, route the tether strap under
the headrest and between the head-
rest posts, otherwise route the tether
strap over the top of the seatback.