Warning And Indicator Lights - Hyundai Coupe Tiburon 2007 Owner's Manual

1
CONTROLS AND EQUIPMENT

WARNING AND INDICATOR LIGHTS

42
SB210G1-E
Turn Signal Indicator
Lights
Operation of a turn signal is indicated
by the warning light located in the in-
strument cluster. If the light fails to
illuminate or does not flash, a malfunc-
tion within the turn signal system is
indicated.
B265C01NF-EAT
Electronic Stability
Program Indicator Lights
(Not all models)
The electronic stability program indica-
tors change operation according to the
ignition switch position and whether the
system is in operation or not.
They will illuminate when the ignition
key is turned to the "ON" position, but
should go out after three seconds. If the
ESP or ESP-OFF indicator stays on,
take your car to your Hyundai authorised
repairer and have the system checked.
See section 2 for more information
about the ESP.
B260U01TB-EAT
Immobiliser Warning
Light
This warning light comes on for some
seconds after the ignition key is turned
to the "ON" position. At this time, you
can start the engine. The light goes out
after the engine is running. In case this
light goes out before you start the en-
gine, you must turn to the "LOCK"
position and restart the engine. In case
this light blinks for five seconds when
the ignition key is turned to "ON" posi-
tion, this indicates that the immobiliser
system is out of order. At this time,
consult to the Hyundai authorised re-
pairer.
SB210M1-E
Charging System
Warning Light
The charging system warning light
should illuminate when the ignition
switch is turned to the "ON" position
and should be extinguished when
the engine is started. If the light fails
to illuminate when the ignition is
turned "ON" or fails to extinguish
after starting the engine, the nearest
Hyundai authorised repairer should be
contacted. If the light illuminates whilst
the vehicle is being driven, stop the
vehicle as soon as it is safe to do so and
check the condition of the alternator
drive belt. If the belt is in place and the
tension is satisfactory, the advice of a
Hyundai authorised repairer should be
sought.
!
CAUTION:
If the drive belt (generator belt) is
loose, broken, or missing whilst the
vehicle is driving, there may be a
serious malfunction, the engine
could also overheat because this
belt also drives the water pump.