Advertisement
DELAYED
ON AND
OFF:
You can set the oven to turn on and off automatically.
The control will calculate the Ume to start cooking.
1. Press COOK TIME.
2. Press UP or DOWN arrow to set how long you want
to bake.
3. Press STOP TIME. The earliest stop time you can set
will appear In the display.
4. Set STOP TIME (the time of day when you want the
oven to turn OFF) by pressing
the UP or DOWN
arrow.
5. Press BAKE.
6. Select temperature by pressing UP or DOWN arrow.
See Fig. 8.
Fig. 8
INCREASE OR DECREASE I
TO SET STOP TIME
INCREASE OR DECREASE
TO SET TEMPERATURE
NOTE:
If the control beeps, you have not completed your timed
oven setting.
Press CLEAR/OFF
and start again with
Step 1.
The low temperature
zone of this range
(between 150°F and 200°F) Is available to
keep hot cooked foods warm. Food kept
longer
than two
hours at these
low
temperatures
may spoil.
Never let food, such as dairy products,
fish, meat, poultry, etc., sit for more
than I hour before cooking starts when
you set your oven for a delay start.
Room
temperature
promotes
the
growth of harmful bacteria.
Be sure the
oven light Is off because heat from the
bulb will speed bacteria growth.
DISPLAY:
Once you have programmed
your control
for any
operation, you can display the setting
by pressing the
appropriate
pad.
For example,
if you are using the
TIMER and want to see the time of day, press CLOCK.
The display will show the time of day.
You cannot set BAKE, BROIL or COOK TIME while the
oven door Is In the locked position.
If you try, the word
"door"
will appear In the display. The oven door lock is
to be used for Self-Cleaning
only.
TONES:
The end-of-cycle tone will sound at the end of timer use
and automatic oven functions. The end-of-cycle tone is
3 short beeps followed by I beep every 6 seconds that
repeat until you press any operation.
If you would like
to eliminate the repeating beeps, push and hold CLEAR/
OFF for ten seconds.
To return the 1 beep every 6
seconds, push and hold CLEAR/OFF
for 10 seconds.
To cancel the end-of-cycle tone, press CLOCK.
F.CODE:
If the time display beeps conUnuously and flashes an
"F" followed by a number, you have a function error
code. Note the number after the "F". Press CLEAR/OFF.
Allow oven to cool for 1 hour.
If problem
repeats,
disconnect
all power to the range and call for service.
Advise your service technician of the number following
the "F" in the display.
8
NCCTL17
Advertisement
