Operational Status (Display) - Kostal PLENTICORE plus Operating Manual

Operation and operating the device
1 2 3

4.5 Operational status (display)

The operational statuses of the inverter are shown on the
display of the inverter:
xxxxxxxx
XX
3800 W
xxxxxx
Fig. 44: "Operational status" display area
Display area, information and inverter status
1
displayed
The following table explains the operational notifications
that can appear on the display:
Display Explanation
Input voltage on the DC side (photo-
Off voltaic modules) is too low or inverter
switched off.
An event is present. Remedial meas-
ures can be found in the "Event codes"
chapter
Bell symbol
The result can be queried in the inverter
menu by going to Service > Event list
or can be called up using the "Down"
arrow key.
© 2018 KOSTAL Solar Electric GmbH
4 4 5 6 7
Ch. 10.5
8 9 10 11
INFO
The user interface/menu entries in
the inverter depend on the installed
inverter firmware (FW) and the user
interface software (UI) in the inverter
and may deviate from the description
provided here.
12 13
84