Operational Status (Display) - Kostal PLENTICORE BI Operating Manual

Operation and operating the device
1 2 3

4.5 Operational status (display)

The operational statuses of the battery inverter are
shown on the display of the battery inverter:
xxxxxxxx
XX
3800 W
xxxxxx
Fig. 37: "Operational status" display area
Display area that shows information and battery
1
inverter status
The following table explains the operational notifications
that can appear on the display:
Anzeige Explanation
Input voltage on the DC side (photovol-
Off taic modules) is too low or the battery
inverter is switched off.
An event is present. Remedial meas-
ures can be found in the "Event codes"
chapter
Bell symbol
The event can be queried in the battery
inverter menu by going to Service >
Event list or can be called up using the
"Down" arrow key.
© 2020 KOSTAL Solar Electric GmbH
4 4 5 6 7
Ch. 9.5
8 9 10 11
INFO
The user interface/menu entries in
the battery inverter depend on the
installed inverter firmware (FW) and
the user interface software (UI) in the
battery inverter and may deviate from
the description provided here.
12
72