Landscape Forms Trapecio Installation Manual

Trapecio

Bench

Included components:

1x ‐ Seat

2x ‐ Support

24x – 9/16"

16x – 1/2 x 3"

I.D. washer

lag screw

• Hardware is bagged in two hardware packs

Tools required:

• hammer drill with masonry drill bits

• safety glasses

• proper equipment or personnel for moving/lifting 710lb. bench

• chemical anchoring adhesive, HILTI HY‐150 Max or equivalent

• 3/4" wrench or socket

• bracing for bench

Date: September 21, 2012

European Community Design RCD 000285622‐0001

Installation Guide

2x – wood

1x ‐ Backrest

drill template

8x – 1/2‐13

8x – 1/2‐13 x 5‐1/2"

hex nut

threaded rod

www.landscapeforms.com Ph: 800.521.2546

Fig. 1 – Surface mount at grade

Fig. 2 – Surface mount below grade

Page 1 of 2

Table of Contents

Need help?

Do you have a question about the Trapecio and is the answer not in the manual?

Page 1 Trapecio Installation Guide Bench www.landscapeforms.com Ph: 800.521.2546 Bench Included components: 2x – wood 1x ‐ Backrest drill template 1x ‐ Seat 2x ‐ Support Fig. 1 – Surface mount at grade 8x – 1/2‐13 8x – 1/2‐13 x 5‐1/2” 24x – 9/16” 16x – 1/2 x 3” hex nut threaded rod I.D. washer lag screw • Hardware is bagged in two hardware packs Tools required: • hammer drill with masonry drill bits • safety glasses • proper equipment or personnel for moving/lifting 710lb. bench • chemical anchoring adhesive, HILTI HY‐150 Max or equivalent •...
Page 2 Trapecio Installation Guide Bench www.landscapeforms.com Ph: 800.521.2546 Fig. 3 – Concrete slab minimum Fig. 6 – Set bench Fig. 6 Set bench INSTALLATION: Prepare site for installation. Fig. 4 – Assemble bench Assemble wood seat and back to supports as shown in Fig. 4. Tighten all screws until snug Lag screws in the slotted holes only see Fig 4 should then be until snug. Lag screws in the slotted holes only, see Fig. 4, should then be loosened 1/4 turn. Refer to side elevation in Fig. 1 for proper orientation of seat and back. Note: each wood component weighs between 250‐350 lbs. Proper personnel or equipment is required for lifting. Protect bench from marring and scratching. Set bench in place. Note: assembled bench weighs approximately 710 lbs. Proper personnel or equipment is required for lifting. Bench needs to be braced.