Simrad HT50 Assembly Instructions Manual page 18

ATIS IDENTIFIER
DSC IDENTIFIER
7.2 Programming.
INITIAL SET UP
The XXXXX programming kit operates in conjunction with an IBM compatible
PC. The programme should be copied to the 'C' drive on the PC hard disc into
a directory entitled H2setup.exe
If using a monochrome monitor type MODE BW80. Connection between the
radio and PC is by means of the programming lead supplied with the kit from
the Antenna Socket on the radio to a 9 pin serial port on the PC.
Enter the programming set up software by typing "H2setup". Programming is
entirely menu driven and self explanatory. (NB. Programme may not run under
WINDOWS 95 / 97 / 98 but operates satisfactorily under 3.1 or 3.11).
This program allows the dealer to configure the H2 series
Radios to any mode including the programming of private channels.
Incorrect use of this program could enable the radios to be used
In order to adjust characteristics, radio must be switched to
simultaneously holding down SHIFT, UP and DW keys
DRAFT
Stores Automatic Transmission
Identification System (ATIS)
Maritime Mobile Service Identity
(MMSI) number.
C:\H2setup.exe
H2 RADIO SETUP PROGRAM
---------------------------------------------------------
Version 1.0
Copyright (C) Simrad-Navico Ltd 1998
WARNING
--------------
in contravention of local regulations.
Which COM port is to be used? (1 or 2)
Type 1, 2 or [ESC] to exit program
"Programming Mode"
by:
whilst pressing ON key
DRAFT 18