ProForm 831.28782 User Manual page 6

.
Press the two H_ndlebar Endcaps (13) onto the
Pedal Frame (7).
Insert the Handlebar (2) into the Pedal Frame
(7). Be sure that the Handlebar is tumed as
shown. Attach the Handlebar to the Pedal
Frame with four #8 x 1/2" Screws (16).
4. Lubricate the indicated axles on the Pedal
Frame (7). Slide a Pedal (12) onto each axle.
Be sure that the Pedals are tamed so the
rounded ends face away from the Pedal Frame.
Using the included pedal tool, tap a 112" Push
Nut (30) onto each of the axles. Sea the inset
drawing. Make sure that the Push Nuts are
turned as shown, with the teeth pointing
away from the Pedal Frame (7).
Attach two Pedals (12) to the other side of the
Pedal Frame (7) in the same manner.
5. Turn the Seat Knob (35) to loosen it. Pull down
the Seat Knob and hold it, Slide the Seat (3)
onto the Seat Frame (5) and move the Seat to
the desired position. Release the Seat Knob.
Slide the Seat back and forth slightly until the
Seat Knob locks into place. Turn the Seat Knob
to tighten it. Push on the Seat to make sure
that the Seat Knob Is engaged in one of the
holes in the underside of the Seat Frame.
3
2 ,
7 J ,3
---L P a, TooY
"I _Teeth
5
5
35
6_