Installation And Configuration; Preliminary Operations; Configuration Through The App - TEXA eTRUCK Technical Manual

11 INSTALLATION AND CONFIGURATION

The following chapters illustrate how to install and configure a device or a series
of devices in sequence.
At the end of the installation and configuration procedures, the device is able to
work only on the vehicle on which it is installed.
Do not install the device on vehicles that do not meet the
compatibility requirements established by TEXA S.p.A.
Do not move the device onto any other vehicle without performing
the installation and configuration procedure.

11.1 Preliminary operations

• Sign up on the eTRUCK WORKSHOP Web Portal
• Get the FLEET MANAGER email address
• Download the WORKSHOP app from Google Play Store or Apple App Store
• Keep the devices to be installed at hand

11.2 Configuration through the App

The following procedure must be performed respecting the times and requests
of the device installation app.
Proceed as follows:
1. Launch the WORKSHOP app.
2. Enter the FLEET MANAGER email address.
3. Identify the device with one of the following modes:
• Scan the QR Code on the device to get its serial number, wait for the app to get
the PIN code via the Internet (default and recommended mode)
• Manually enter the serial number indicated on the device, wait for the app to get
the PIN code via the Internet (use this mode if scanning the QR Code is not
possible)
• Manually enter the serial number and PIN code indicated on the device (use this
mode if no Internet connection is available)
4. Enter the vehicle's license plate number when requested to by the app.
5. Select the Make and Model using the specific drop-down menus.
6. Connect the device to the vehicle as explained in the section Installation in
the Vehicle.
7. Launch the Bluetooth configuration.
The configuration procedure is complete.
en
23