Recommended Autotune Procedure; Sensor Data - Vance and hines Fuelpak FP3 User Manual

AUTOTUNE / SENSOR DATA

RECOMMENDED AUTOTUNE PROCEDURE

1. After initializing Autotune, ride the bike for 20-60 minutes
2. Upon completion, turn off your motor and connect to the FP3 app
3. Go to your Autotune table and press 'Apply Values', then press 'Apply' and follow
on screen prompts to fl ash.
4. Repeat steps 1-3 for a second session of 20-60 minutes
5. Repeat steps 1-2 for a third session of 20-60 minutes
6. After completing your third session, turn off your motor and connect to the FP3 app
7. Go to your Autotune table and press 'Apply Values', then press 'Finish' and follow
on screen prompts to fl ash

SENSOR DATA

There are 5 readouts available on screen. One in the center, and one in each corner.
To customize your readouts:
• Press the readout you want to change
• Turn the dial selector in center of screen to desired readout
• Press center of screen to accept the readout
NOTE: Readouts available depend on the year and model of the bike.
13
INSTRUCTION