Hardmounting The Csl Elite Wheel Base - FANATEC CSL Elite Wheel Base Manual

5.3 Hardmounting the CSL Elite Wheel Base

The CSL Elite Wheel Base offers a three-point hardmount opportunity on the
bottom side of the CSL Elite Wheel Base, see marked on the right hand side
picture below. To hardmount the Wheel Base first disassemble the two blocks
from the bottom side with Allen Key 3 mm (not included), see highlighted on the
left hand side picture below:
IMPORTANT:
the screw length so that the thread does not reach more than 16 mm into
the wheel base. Example: If your table thickness is 20 mm the screw must
not exceed a total thread length of 36 mm! Always use all three hard-
mount points to allow a proper and stable fixation and avoid damages!
To hardmount the CSL Elite Wheel Base to a table or rig by screws please
find the printable drilling template in the download area of our website
www. fanatec.com.
11
Used screws have to be good quality M6 screws. Chose
Table
max 16mm
X