CAUTION: Use the attached specified cables with this monitor so as not to interfere with radio and television reception.
For mini D-sub 15 pin, please use a signal cable with ferrite core.
For HDMI and DisplayPort, please use a shielded signal cable. Use of other cables and adapters may cause
interference with radio and television reception.
The power supply cord you use must have been approved by and comply with the safety standards of U.S.A., and meet
the following condition.
Power supply cord
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions.
The user may find the following booklet, prepared by the Federal Communications Commission, helpful: "How to Identify
and Resolve Radio-TV Interference Problems." This booklet is available from the U.S. Government Printing Office,
Washington, D.C., 20402, Stock No. 004-000-00345-4.
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
To see a list of our TCO certified monitors and their TCO Certification (in English only), visit our website at
Non shield type, 3-conductor
U.S. Responsible Party: NEC Display Solutions of America, Inc.
Type of Product:
Equipment Classification: Class B Peripheral
We hereby declare that the equipment specified above conforms
to the technical standards as specified in the FCC Rules.
500 Park Boulevard, Suite 1100
Itasca, Illinois 60143
MultiSync E271N (M277D4)