Table of Contents
Advertisement
You can use Wireless Remote Control BR-E1 (sold separately, p.174) to
start and stop the time-lapse movie shooting.
With Wireless Remote Control BR-E1
z
• First pair the Wireless Remote Control BR-E1 with the camera (p.408).
• Set [ z 2: Remote control] to [Enable].
• Take test shots, then when the camera is ready to shoot (as in step 14
on page 230), set the BR-E1's release mode/movie shooting switch
to < o > (immediate release) or <2> (release after 2-sec. delay).
• If the remote control's switch has been set to [ k ], the time-lapse
movie shooting cannot start.
Camera status/remote
control setting
Test-shooting screen
Shooting-ready
During time-lapse movie
shooting
Approx. Time Available for Shooting Time-lapse Movies
For guidelines on how long you can shoot time-lapse movies (until the
battery runs out), see page 613.
<2> 2-sec. delay
< o > Immediate
release
Test-shooting
Starts shooting
Ends shooting
Shooting Time-lapse Movies
[ k ] Movie shooting
To shooting-ready
To test-shooting screen
Ends shooting
235
Advertisement
Table of Contents
