Auto Power Off; Replacing Batteries; Connecting The Power Cord; Plug In The Power Cord - Decatur Electronics Surface Velocity Radar SVR2-01 User Manual

3.8.1 Auto Power Off

If no trigger or key press is detected the SVR™ will automatically
power off after 50 minutes in order to conserve battery life .

3.9 Replacing Batteries

When replacing the batteries with new ones remember to use only
rechargeable Nickel-Metal-Hydride batteries and to replace ALL the
batteries at the same time even if you suspect that only one battery is
bad . Follow the instructions listed in steps 3 .2 through 3 .7 for proper
installation and charging when replacing batteries .

3.10 Connecting the Power Cord

If you choose to run off the power cord instead of the internal
batteries, connect the power cord to the receptacle on the bottom
of the SVR™ being sure to properly align the plug on the power cord
to the connector on the bottom of the SVR™ . The SVR™ automatically
will switch from the internal batteries to the power cord for power
when the unit is turned on .

3.11 Plug In the Power Cord

Plug the radar's power cord into your vehicle's cigarette lighter
receptacle . If you are using a separate battery pack as a power source,
plug the radar's power cord into the battery pack's receptacle .

3.12 Control Panel Functions

The operation of the SVR™ is controlled by the five-button key pad
and the trigger .
15