Getting Started - Precor Precision Series Owner's Manual

Getting Started

As you get to know your new Precor
own fitness goals, you'll use the advanced features of
the equipment more often. To begin with, though,
here's an easy way to start out.
Note: These instructions assume that your equipment
has been completely installed and set up.
WARNING
Read through ALL of the safety
information in this manual before you
use the equipment.
To get started with your new EFX:
1. Turn the equipment on if necessary.
2. If the locking pin is engaged, release it (refer to
Using the Locking Pin).
3. Hold one handrail and step onto the pedals.
4. Grasp the handlebars securely.
5. Touch one of the following buttons:
–
Go (to start the suggested workout)
–
QuickStart
Getting Started
® EFX ® and your
6. Use the motion controls to adjust the intensity of
your workout. The control on the left adjusts
CrossRamp ® height, and the control on the right
adjusts resistance.
Figure 6: Motion controls
7. If you need to end your workout early, touch
Pause, then Finish, and finally Home.
Note: A thin protective sheath covers the roller arm
wheels on your EFX. As you exercise, the roller arms
move up and down the ramp and the wheels tend to
squeak until the protective sheath wears off. Any noise
from the wheels is normal and will stop after a break-in
period. Please allow a break-in period of approximately
ten hours before calling Customer Support.
11