Operation And Maintenance; Starting The Autoloader - Seagate Scorpion 240 DDS-4 Installation Manual

Scorpion 240 Autoloader Installation Manual

Operation and maintenance

This section describes how to use your Scorpion 240
autoloader and DDS-4 cartridges. It also explains how to
interpret the LEDs and the display on the front of the drive,
which are shown in Figure 8.
Figure 8. Front view of internal Scorpion 240 autoloader
(external drive is similar)

Starting the autoloader

Turn on all SCSI devices attached to your computer before
you turn on the computer. When the autoloader is first started,
the following events should occur:
1. The Clean, Media, and Drive LEDs light up for two
2. The LCD display shows the current SCSI ID, followed by
3. If a magazine is loaded, the LCD display shows the
Clean
Media
LED
LED
(green)
(green)
seconds, then start flashing.
the message, "WAITING SELFTEST."
message "SCAN X" while the drive determines which
slots in the magazine contain cartridges.
LCD
Drive
Display
LED
(amber)
A-21
EJECT
Button
SELECT
Button
ENTER
Button