Seagate Scorpion 240 DDS-4 Installation Manual page 34

A-32
LCD Message
READY
READY TAPE X
REPLACE CLEANING
TAPE
REWIND TAPE X
SCAN X
SEARCH TAPE X
SELECT X
PUSH ENTER
SELECT PREVENT
UNLOAD TAPE X
UPDATING FIRMWARE
WAITING
SELFTEST
WRITE TAPE X
Scorpion 240 Autoloader Installation Manual
Description
The autoloader has scanned all cartridge slots in the
magazine and is ready to perform an action.
There is a tape (from slot X) in the tape drive and the
autoloader is ready to accept commands.
The cleaning cartridge has been used up and must be
replaced with a new cleaning cartridge.
The tape drive is rewinding the tape cartridge from slot X.
The autoloader is sequentially scanning the cartridge slots
in the magazine.
The tape drive is searching the tape cartridge from slot X.
This message displays when you press the Select button.
Press the Select button repeatedly to display the desired
tape number (X); then press the Enter button to load the
selected tape into the drive.
The autoloader is preventing you from selecting a tape to
load because a Prevent Media Removal command has
been issued by the host. This prevents the tape that is in
the drive from being ejected.
The tape drive is unloading the tape cartridge from slot X.
The autoloader or tape drive firmware is being updated.
This message displays while the tape drive is performing a
Power-On Self-Test (POST) during startup.
The tape drive is writing to the tape cartridge from slot X.