Clearing Batch Quantities; Maintenance And Troubleshooting; Maintenance - Cassida C200 User Manual

Repeat procedure to set the desired batch quantities for other coin denominations.
The C200 will stop when a desired batch quantity is completed for any of the
denominations. The denomination will be displayed on the left and the total count for that
denomination will be displayed on the right side of the screen.
NOTE: When operating in batch mode, the C200 will keep a running total for
each denomination coin. For example, after four batches of 50 fils have
been dispensed, the C200 will stop and display:
To resume counting, press "START/STOP" button.
Pressing the "C" button will reset the count and the machine will start batching from zero.
The batch quantities you choose will be stored in the C200's internal memory, and will not
be reset when the machine is turned off.

2.5 Clearing Batch Quantities

You may clear batch quantities for each denomination by pressing "BATCH" button until
C200 displays " " message on the control panel.
12
3.

MAINTENANCE AND TROUBLESHOOTING

3.1 Maintenance

Most operational problems can be avoided by regular care and preventative maintenance.
Taking regular care of your coin sorter will significantly increase its lifetime and help you
avoid costly repairs.
IMPORTANT: You should always turn the machine off and
disconnect the power cord before cleaning the machine.
To get the best results out of your machine, the following maintenance is recommended on
a regular basis:
Clean all external parts of the machine with a Cassida air duster or a soft cloth. Do not
use solvents, as they may damage the C200.
Clean all the sensors using the procedure described below.
1. Remove the three housing screws and carefully lift up the housing.
2. Clean all sensors and other dusty parts using a Cassida air duster followed by a CleanPro
swab. See Figure 6 for sensor locations.
3. Replace the housing. The housing must be properly lined up with the AC power cord at
the back of the machine. Do not force the housing into place, as this could damage the coin
feed mechanism built into the housing.
Cassida C200 coin counter/sorter/wrapper 13