Page 3
This manual contains important information on safety measures and operational features of the Cassida Cube Mixed Bill Counter. Please read it carefully before operating your mixed bill counter and keep it handy for future reference.
Page 4
Table of contents: 1. INTRODUCTION ____________________________________________________________ 2 1.1 About the Cassida Cube ________________________________________________ 2 1.2 Box contents ____________________________________________________________ 2 1.3 Front and rear views ____________________________________________________ 3 1.4 Control panel ___________________________________________________________ 4 1.5 Specifications ___________________________________________________________ 5 1.6 Importand safety notes __________________________________________________ 6 2.
INTRODUCTION About the Cassida Cube Thank you for choosing the Cassida Cube compact value counter. We hope you enjoy using it. The Cassida Cube is the most sophisticated compact mixed value counter on the market today. It applies the latest technology to give you the ultimate in counting performance and counterfeit detection.
DC12V 12.0A Battery: 2000 mAH Operating temparture: 32 - 104 °F (0-40 °C) Storage temprature: -13 - 149 °F (-25 - +65 °C) Size: 6.6” x 5.9”x 5.9” (170x150x150 mm) Weight: 4.2 lbs (1.9 kg) Cassida Cube compact value counter...
Page 9
Important safety notes When using this unit, basic safety precautions should always be observed, including the following: • Read this manual before operation • The manual should be available to operator • Do not use this unit in areas where it may be exposed to water or any other liquids •...
NOTE: For optimal counting of US currency, the hopper guide should extend no farther than 16.5 cm (approximately 6.5 inches) from the edge f the Cube. The bill pressing wire should be extended to its full length. Please follow guidelines shown on the affixed stickers.
1. Open USD=Narrowest setting Open and adjust the hopper 1. Open USD=Narrowest setting Open tilt stand Unfold from bottom rear (for best performance) Unfold from bottom rear (for best performance) ®...
• The battery status symbol will not be displayed Low Battery on-screen if a battery is not connected. • If the device works on a battery, then in working mode, when the counter idles up to 20 minutes, it will turn off automatically. Cassida Cube compact value counter...
(Time Set, Auto-Start, and Sleep Time) Press for 2 seconds, machine will perform a self-test (see Figure 3-1). Powers the Cube on or off (Press and hold) Low Battery If the self-test is successful, the machine will enter into ready state (see Figure 3-2),...
Page 14
Arrange a stack of bills with smaller denominations in the middle, where possible. Then set the hopper guide to the position where it just touches the edges of the bills. While standing in front of the Cube, lay the bills flatly on the hopper. The Switches between counting currency Cube will begin counting automatically.
OFF. To confirm and leave the settings menu, press MENU (Time Set, Auto-Start, and Sleep Time) Cycles through the batch amounts Ver. 2.10 Powers the Cube on or off (Press and hold) PCS: Accesses settings ( 100 / 50 / 25 / 20 / 10 ) Switches between...
Page 16
Prints a report (with optional printer) Cycles through the batch amounts Powers the Cube on or off (Press and hold) machine will stop and alert the user with a DENOMINATION DIFFERENT warning. Cycles through the batch amounts ( 100 / 50 / 25 / 20 / 10 )
B:--- Tot a l (for counting coupo Free Total To connect the Cube to a printer, follow the diagram as shown. The Cassida Number Switches between MODE Cube has a special print cable that is included with your unit. Turns...
Prints a report (with optional printer) Accesses settings MENU (Time Set, Auto-Sta Accesses settings Powers the Cube on or off (Press and hold) MENU (Time Set, Auto-Start, and Sleep Time) Displays an on-screen report Powers the Cube o Starts or continues the count...
( 100 / 50 / 25 / 20 / 10 ) Turns mode on or off (press and hold) Powers the Cube on or off (Press and hold) Cycles through the batch amounts Clears the batch amount ( 100 / 50 / 25 / 20 / 10 )
Please use a brush compressed air to remove dust from the sensor. Remove any jammed bills and restart the machine. To clean or clear, turn off machine and open by lifting tab Cassida Cube compact value counter...
Page 21
(Time Set, Auto-Start, and Sleep Time) Internal memory fault Reset unit to factory settings by holding both Accesses settings Powers the Cube on or off (Press and hold) while the unit is off. After a MENU (Time Set, Auto-Start, and Sleep Time) self test, “Set default parameter”...
Switches between MODE Accesses settings Sort Powers the Cube on or off (Press and hold MENU (Time Set, Auto-Start, and Slee Incomplete notes Half or incomplete bill. Remove the bill from the Cycles through the batch amounts...
Be certain to avoid contact between the nozzle and any surfaces, to assure no damage occurs to sensors. Cassida can service your Cube, if necessary, even if the repair is not covered under than warranty. To get a maintenance or service quote, please log on to Cassidausa.com/support and fill out a support form.
Cassida is happy to service your Cube even if is not covered under warranty. To request service please log on Cassidausa.com/service and fill out a form requesting service. Shipping The warranty does not cover the cost of shipping to Cassida’s Technical Service Center.
Page 28
Cassida Corporation - North America Printed in China 2015 Cassida Corporation. All rights reserved. Specifications subject to change without notice. Cassida is a registered trademark of Cassida Corporation. FN CubeREV 0116...