Cleaning Air Inlet Grille; Install And Change Air Purifier; Clean Outlet Vent And Surface Panel - Ouellet CCD12KCHVS-I Owner's Manual

CLEANING AIR INLET GRILLE

• Open air inlet grille (See step 1 of CLEANING THE FILTER section)
• Remove the air filter (See step 2 of CLEANING THE
FILTER section)
• Take out the air inlet grille. Open air inlet grille
at a 45° angle and raise it, as shown opposite.
• Clean it with a dry cloth or lightly moistened with
water (below 45 °C) to wipe it.
• Let the inlet grille dry in a shady and cool place.
• Reinstall the air inlet grille.
• Reinstall the air filter (See step 4 of CLEANING THE FILTER section).
• Close air inlet grille (Opposite of step 1 of CLEANING THE FILTER section).
INSTALL AND CHANGE AIR PURIFIER
• Open air inlet grille (See step 1 of CLEANING THE FILTER section).
• Remove purifier fixed on the filter by unscrewing fixing bolts.
• Replace it with a new one.
• Reinstall the air filter (See step 4 of CLEANING THE FILTER section).
Purifier filter
Stand for purifier
Fix bolt of purifier
CLEAN OUTLET VENT AND SURFACE PLANEL
• Clean it with a dry cloth or lightly moistened with water (below 45 °C) to wipe it.
• If the guide louver is too dirty, it may be removed to be cleaned.
• Using a screwdriver, loosen 2 screws at both end of guide louver.
• Rotate guide louver slightly to install the protruding edges into grooves on both end of the guide
louver and tighten the bolts.
NOTE:
Do not wipe guide louver too hard when cleaning, otherwise layers of painted surfaces would fall off.
Air filter
29