Cleaning Instructions; Front Panel; Indoor Unit; Nanoe-G Generator - Panasonic CS-E9TKA Operating Instructions Manual

Cleaning instructions

To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. Dirty unit may cause malfunction
and you may see nanoe-G indicator blinks or
error code "H99". Please consult authorised
dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fi n, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap (
detergent.
• Do not use water hotter than 40 °C / 104 °F.

Indoor unit

Wipe the unit gently with a soft,
dry cloth.
Human activity sensor
Do not hit or violently press or poke it with a sharp
object. This can lead to damage and malfunction.

Front panel

Wash gently and dry.
Remove the front panel
2 Pull out and lift up
1 Release the
hooks at
both ends
Close it securely
3 Close down
4 Press both ends and center of the front panel
10
pH 7) or neutral household
2 Push in
1 Insert
Indoor unit
Front panel
Human activity
sensor

nanoe-G Generator

Once every 2 weeks
• Clean with dry cotton bud.
• Do not touch during operation.
Air fi lters
Once every 2 weeks
• Wash/rinse the fi lters gently
with water to avoid damage to
the fi lter surface.
• Dry the fi lters thoroughly under shade, away
from fi re or direct sunlight.
• Replace any damaged fi lters.
Remove air fi lter
For seasonal inspection after extended
non-use
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select COOL/
HEAT operation. After 15 minutes of
at both
operation, it is normal to have the following
sides
temperature difference between air inlet and
air outlet vents:
COOL: ≥ 8 °C / 14.4 °F
For extended non-use
• Activate HEAT mode for 2~3 hours to remove
moisture left in the internal parts thoroughly to
prevent mould growth.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
Aluminium fi n
Air fi lters nanoe-G Generator
Attach air fi lter
Insert into the unit
HEAT: ≥ 14 °C / 25.2 °F