Cleaning Instructions - Panasonic CS/CU-HU12ZKY Series Operating & Installation Instructions Manual

Cleaning instructions

To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. A dirty unit may cause malfunction.
Please consult authorised dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fin, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap ( pH 7) or neutral household
detergent.
• Do not use water hotter than 40 °C.
Indoor unit
Wipe the unit gently with a soft,
dry cloth.
Dust filters
Every 2 weeks
• Wash/rinse the dust filters gently
with water to avoid damage to the
filter surface.
• Dry the dust filters thoroughly under shade,
away from fire or direct sunlight.
• Replace any damaged filters.
Please remove the Ag Clean
the dust filter with water. Ag Clean
models only.
Remove air filter
**PM 2.5 Sensor
For better detection of AQI Level, as and when
required you may need to clean sensor lens as
per below process.
• Turn off main power supply.
• Open the Front Panel.
• Peel off the tape on sensor surface (as shown image).
• Clean the lens with cotton swab, after that paste
the tape at same location.
Note : Dirt on the lens may lower sensor sensitivity. Do not scratch the
lens with something hard.Do not use alcohol or cleanser to wipe the dirt.
Filter / PM0.1 Filter before wash/rinse
+
filter applicable to specific
+
Attach air filter
Indoor unit
Front panel **PM 0.1 filters
**Ag Clean
+
Filter
Dust filters
**nanoe-G Generator
For better efficiency, please clean generator
brush regularly as per below process.
• Turn off main power supply.
• Clean with dry cotton bud.
• Do not touch during operation.
**Ag Clean Filter & **PM 0.1 filter
+
Ag Clean
• Clean the filter whenever necessary.
• Don't wash/rinse the filter with water.
• The surface of the filter shouldn't be rubbed
with any object.
• The filter shouldn't be pulled with strong force
as it may get damaged.
For seasonal inspection after extended
non-use
• Checking of remote control batteries.
• No obstruction at air inlet and air outlet vents.
• Use Auto OFF/ON button to select COOL
operation. After 15 minutes of operation, it
is normal to have the following temperature
difference between air inlet and air outlet
vents:
COOL: 8 °C
For extended non-use
• Activate nanoe-G operation for 2~3 hours as
an alternative to remove moisture left in the
internal parts thoroughly to prevent mould
growth.
• Turn off the power supply and unplug.
• Remove the remote control batteries.
Note:
** Applicable for selected models.
nanoe-G
Generator
Aluminium fin
Filter / PM 0.1 filter.
+
13