Resistance Does Not Respond - Bowflex Max Trainer M6 Service Manual

Resistance Does Not Respond

BEGIN HERE
Replace the console.
NO
Does the
increase resistance level
button on the console
make a clicking noise
when you press it?
YES
Replace cable to Speed
Sensor.
Does the resistance
respond now?
YES
Issue resolved.
Cycle the power off/on.
If the issue persists
continue on with the
troubleshooting.
Remove the right side
YES
lower round cover.
Plug the power cord back in, and power up the display. If the inlet wire
was unplugged, plug it back in.
NO
Replace the Servo
Motor.
NO
Does the console turn
on?
YES
Does the fan turn
freely?
Press
"START / ENTER"
twice.Does the motor move
when pressing the increase or
decrease resistance buttons?
Visually watch the motor.
Reattach / adjust the
tension cable
Replace the brake
assembly.
Replace the cable.
Go to Troubleshoot-
ing: Rubbing / Belt
14
Go to Troubleshoot-
NO
ing: No Power
Go to Troubleshoot-
NO
ing: Machine Seized
Up
Visually inspect the
motor. Check to make
YES
sure that the metal cable
is properly attached to
the motor and the brake
arm.
Has the
metal tension cable
YES
come off track, or need
adjustment?
NO
Is the red, magnetic
YES
brake arm broken?
NO
Is the metal tension
YES
cable broken?
NO
Does the fan
rotate when pedaling
NO
the machine?
YES